Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Ridgeline V6-3.5LFACTORY OEM SERVICE PROCEDURE
Instrument Panel Control Module: Service and Repair
Gauge Control Module Replacement
NOTE: Before replacing the gauge control module, do the Rewriting the ODO Data and Transferring the Maintenance Minder Data on a New Gauge Control Module procedure Programming and Relearning.
1. Remove the instrument panel Instrument Panel Removal/Installation.
2. Remove the screws from the gauge control module (A), and spread a protective cloth (B) on the upper column cover.
3. Disconnect the connectors (C), and remove the gauge control module.
4. Install the gauge in the reverse order of removal.
5. Rewriting the ODO data and transferring the maintenance minder data to a new gauge control module Programming and Relearning.
NOTE: Check any official Honda service website for more information on how to write odometer information to a gauge control module that will not communicate with the HDS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.