Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Ridgeline V6-3.5LFACTORY OEM SERVICE PROCEDURE
Keyless Entry
- Description and Operation
- Testing and Inspection
- Symptom Related Diagnostic Procedures
- Doors Automatically Relock After Being Unlocked With The Transmitter Even Though a Door Has Been Opened
- Doors Will Not Unlock (or Lock) With The Transmitter, But Will Unlock (Lock) With The Door Switch
- Keyless Operation Does Not Work (LOCK, UNLOCK, PANIC)
- Keyless/Power Door Locks/Security System Symptom Troubleshooting Index
- Security Alarm System Will Not Arm
- The Horn Does Not Sound And/Or The Headlights Do Not Flash When The Panic Button On The Transmitter Is Pressed
- Component Tests and General Diagnostics
- Driver's Door Key Cylinder Switch Circuit Troubleshooting
- Driver's Door Lock Knob Switch Circuit Troubleshooting
- Driver's Door Switch Circuit Troubleshooting
- Front Passenger's Door Lock Knob Switch Circuit Troubleshooting
- Front Passenger's Door Switch Circuit Troubleshooting
- In-Bed Trunk Lid Latch Switch Circuit Troubleshooting
- Security Hood Switch Circuit Troubleshooting
- Left Rear Door Lock Knob Switch Circuit Troubleshooting
- Right Rear Door Lock Knob Switch Circuit Troubleshooting
- Left Rear Door Switch Circuit Troubleshooting
- Right Rear Door Switch Circuit Troubleshooting
- Door Key Cylinder Switch Test
- Door Lock Knob Switch Test
- Keyless Entry Transmitter Test
- Keyless/Power Door Locks/Security System (MICU, Relay Control Module, And Door Multiplex Control Unit) Input Test
- Power Door Lock Switch Test
- Symptom Related Diagnostic Procedures
- Locations
- Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
