Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Ridgeline V6-3.5LFACTORY OEM SERVICE PROCEDURE
Subframe: Service and Repair
Subframe Replacement
Special Tools Required
- Subframe Alignment Pin 070AG-SJAA10S
Front Subframe Torque
After removing the subframe mounting bolts and the front subframe stiffener mounting bolts, be sure to replace them with new ones.
Front Subframe Alignment
NOTE: Align the front subframe alignment with the subframe alignment pin.
1. Align the front suspension subframe (A) in the following sequence.
- Lift the front suspension subframe up to the body, and loosely install new subframe mounting bolts and the brackets (B).
- Insert the subframe alignment pin (C) into the alignment hole in the right rear of the subframe, then align the subframe with the body.
- Loosely tighten the subframe mounting bolt (D) at the right rear.
- Insert the subframe alignment pin into the positioning hole in the left rear of the subframe, and then align the subframe with the body.
- Loosely tighten the subframe mounting bolt (E) at the left rear.
- Loosely tighten both front subframe mounting bolts (F).
- Insert the subframe alignment pin into the positioning hole in the right rear of the subframe.
- Tighten the mounting bolt to the specified torque.
- Tighten the remaining subframe mounting bolts and the bracket mounting bolts (G, H) to the specified torque.
2. After reinstalling all removed parts, check and adjust the front wheel alignment Service and Repair.
Rear Subframe Torque
NOTE:
- When installing, align both installation reference holes in the subframe with the reference holes in the body with a screwdriver or tapered punch as a guide.
- After removing the subframe mounting bolts, be sure to replace them with new ones.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
