Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Honda Ridgeline RTFACTORY OEM SERVICE PROCEDURE

Back Power Window Motor Test

Remove the rear panel trim (see REAR PANEL INSULATOR REPLACEMENT ).
Disconnect the 6P connector (A) from the back window motor.

Fig 1: Identifying Back Window Motor 6P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Test the motor by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.

Fig 2: Terminal Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the motor does not run or fails to run smoothly, replace the back window middle glass regulator (see BACK WINDOW MIDDLE GLASS REGULATOR REPLACEMENT ).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.