2012 Honda Pilot 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Fuel Tank Pressure Sensor: Service and Repair




FTP Sensor Replacement

1. Raise the vehicle on a lift.

2. Remove the EVAP canister cover.

3. Disconnect the FTP sensor connector (A).

Factory service manual diagram





4. Disconnect the hose (B), and remove the FTP sensor (C).

5. Install the parts in the reverse order of removal with a new O-ring (D) and a new retainer (E).

NOTE: Do not coat the O-ring with oil.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.