2012 Honda Pilot 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Service and Repair




CMP Sensor Replacement

1. Remove the timing belt Timing Belt Removal.

2. Remove the front camshaft pulley (CMP sensor pulse plate) (A).

Factory service manual diagram




3. Disconnect the CMP sensor connector (B), then remove the back cover (C).

4. Remove the CMP sensor (A) from the back cover.

Factory service manual diagram




5. Install the parts in the reverse order of removal. Install the timing belt Timing Belt Installation.

6. Do the CKP pattern clear/CKP pattern learn procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.