Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Pilot 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Rear Control Panel Removal/Installation
Rear Control Panel Removal/Installation
SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.
1. Remove the console rear trim Center Console Removal/Installation.
2. Remove the self-tapping screw from the console rear trim, disconnect the connectors and remove the upper duct (A).
3. Remove the self-tapping screws and the rear control panel (A).
4. Install the control panel in the reverse order of removal. After installation, operate the various functions to see whether it works properly.
5. Run the self-diagnostic function to confirm that there are no problems in the system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.