2012 Honda Odyssey V6-3.5LFACTORY OEM SERVICE PROCEDURE

Electric Load Sensor: Service and Repair




ELD Replacement

1. Do the battery terminal disconnection procedure Procedures.

2. Remove the upper cover (A), then remove the two positive (+) terminals (B).

Factory service manual diagram




3. Remove the fuses (C and D).

4. Remove the main under-hood fuse box (A) from the bracket.

Factory service manual diagram




5. Remove the lower cover (B).

6. Release the two lock tabs (A), then pull the ELD (B) out from the main under-hood fuse box (C).

NOTE: Take care not to damage wire harness.

Factory service manual diagram




7. Disconnect the ELD 3P connector (D).

8. Install the parts in the reverse order of removal.

9. Do the battery terminal reconnection procedure Procedures.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.