Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Odyssey V6-3.5LFACTORY OEM SERVICE PROCEDURE
Rear A/C Control Unit Replacement
Rear A/C Control Unit Replacement
1. Remove the right rear side trim panel Interior Trim Removal/Installation - Rear Side Area.
2. Disconnect connectors (A) from the rear A/C control unit (B), then remove the self-tapping screws and the rear A/C control unit from the rear HVAC unit.
3. Install the rear A/C control unit in the reverse order of removal. After installation, operate the various functions to see whether it works properly.
4. Run the self-diagnostic function to confirm that there are no problems in the system How to Troubleshoot the Rear A/C System.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
