2012 Honda Odyssey EXFACTORY OEM SERVICE PROCEDURE

Engine Electrical

ENGINE ELECTRICAL SPECIFICATIONS

Item Measurement Qualification Standard or New Service Limit
Ignition coil Rated voltage   12V
Firing order   1-4-2-5-3-6
Spark plug Type NGK DILZKR7A11G
Gap   1.0-1.1 mm (0.039-0.043 in) -
Ignition timing At idle
Check the red mark
In N or P 10±2°BTDC
Drive belt Tension   Auto-tensioner
Alternator Output At 13.5 V and normal engine temperature 130 A
Coil (rotor) resistance At 68 °F (20 °C) 2.5 Ω
Slip ring O.D.   14.4 mm (0.567 in) 14.0 mm (0.551 in)
Brush length   10.5 mm (0.413 in) 1.5 mm (0.059 in)
Brush spring tension   3.2 N (0.33 kgf, 0.73 lbf) -
Starter Output   1.8 kW
Commutator mica depth   0.50-0.90 mm (0.0197-0.0354 in) 0.20 mm (0.0079 in)
Commutator runout   0.02 mm (0.0008 in) max. 0.05 mm (0.0020 in)
Commutator O.D.   28.9-29.0 mm (1.138-1.142 in) 28.0 mm (1.102 in)
Brush length   15.0-16.0 mm (0.591-0.630 in) 9.0 mm (0.354 in)
Brush spring tension (new)   22.26-27.26 N (2.270-2.780 kgf, 5.004-6.129 lbf) -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.