2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE

Driven Pulley Pressure Sensor Removal/Installation

  1. Remove the CVT driven pulley pressure sensor (A).
    Fig 1: CVT Driven Pulley Pressure Sensor With Torque Specifications
    G08093360Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the new CVT driven pulley pressure sensor and a new sealing washer (B), and tighten the sensor.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.