Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE
A/T Gear Position Indicator Panel Replacement
NOTE:
Do not wipe off the grease that is applied to the portion of the shift lever marked with an asterisk (*) when you disassemble or assemble It because a special grease is used.
- Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
- Apply the parking brake, and move the shift lever to N.
- Wrap the end of a thin blade screwdriver with tape, pry the shift lever knob cover (A), and remove it.
- Remove the screws (B) and the shift lever knob (C).
- Remove the A/T gear position indicator panel light socket (A).
- Wrap the end of a thin blade screwdriver with tape, and pry up the A/T gear position indicator panel (B) by releasing the four locks (C) from the shift lever bracket base (D).
- Remove the lever cover (A) from the A/T gear position indicator panel (B).
- Check the lever cover for wear and damage, and replace it if necessary.
- Install the lever cover to the new A/T gear position indicator panel.
- Install the A/T gear position indicator panel (A) to the shift lever bracket base (B), and push the locks (C) to the hooks (D) securely.
- Install the A/T gear position indicator panel light socket (E).
- Install new screws (A) to secure the shift lever knob to the shift lever (B).
- Install the shift lever knob cover (C) by pushing the shift lever knob cover onto the shift lever knob securely.
- Install the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
- Shift the shift lever to P.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
