2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE

TPMS Reset Procedures: Notes

NOTE: When a tire pressure sensor or control unit is replaced, or a known good wheel is substituted, the ID(s) of all four tires' sensors must be memorized by the TPMS control unit. See Memorizing Sensor IDΒ . After memorizing the sensor ID(s) or doing a tire rotation, the mounting location of sensors 1, 2, 3 and 4 must be determined. SeeSensor LocationΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.