2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE

Fuel Tank Unit Removal and Installation: Installation

  1. Temporarily attach a new base gasket (A) to the fuel tank unit (B), then insert the fuel tank unit partially into the fuel tank.
    NOTE:
    • Be careful not to damage the new base gasket.
    • Be careful not to bend the fuel gauge sending unit.
    • Do not coat the base gasket with oil.
      Fig 1: Identifying Base Gasket And Fuel Tank Unit
      G08092558Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Transfer the base gasket (A) from the fuel tank unit to the fuel tank.
    Fig 2: Identifying Correct/Incorrect Method Of Aligning Marks Of Fuel Tank And Fuel Tank Unit
    G08092559Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Align the marks (B) on the fuel tank and fuel tank unit, then insert the fuel tank unit into the fuel tank until the fuel tank unit rests on top of the base gasket.
    NOTE: To avoid a fuel leak, check the base gasket, visually or by hand, to make sure it is not pinched.
  4. Using the special tool, tighten a new locknut (A) with a new locknut plate (B) to the specified torque.
    NOTE: Before tightening, align the marks (C) on the locknut with the start of the threads (D).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.