2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE

Enable Conditions

Condition Minimum Maximum
Elapsed time after monitor finishing condition except immediate starting the engine 1.0 second -
Engine coolant temperature None, unless the initial engine coolant temperature is 14 Β°F (-10 Β°C) or less, in which case the monitor will not run until the engine coolant temperature reaches 68 Β°F (20 Β°C)
Engine speed 500 rpm 6,200 rpm
MAP value(1) 750 rpm 27 kPa (7.8 inHg, 197 mmHg) -
2,000 rpm 25 kPa (7.2 inHg, 181 mmHg) -
Fuel feedback Other than during fuel cut-off operation
No active DTCs set (prevents monitor from running) P0107, P0108, P0117, P0118, P0122, P0123, P0222, P0223, P0335, P0339, P1109, P2227, P2228, P2229
Other Test-drive on a flat road to avoid misdetection
(1) Varies with driving conditions.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.