Special Tools Required

Universal Lifting Eyelet 07AAK-SNAA120
Engine Support Hanger, A and Reds AAR-T1256*

*Available through the Honda Tool and Equipment Program 888-424-6857

NOTE: IMA components are located in this area. The IMA is a high-voltage system. You must be familiar with the IMA system before working on or around it. Make sure you have read the IMA service precaution before doing repairs or service (see SERVICE PRECAUTIONS ).

Raise the vehicle on the lift, and position the engine/IMA motor/transmission under the vehicle. Be sure that they are properly aligned. Carefully lower the vehicle until the engine/IMA motor/transmission are properly positioned in the engine compartment. Make sure the vehicle is not resting on any part of the engine/IMA motor/transmission. Support the engine/IMA motor/transmission with a chain hoist (A) and carefully raise the engine/IMA motor/transmission into place.
NOTE:
- Attach the first universal lifting eyelet (07AAK-SNAA120) to the cam chain case (see step 53).
- Reinstall the mounting bolts and support nuts in the sequence given in the following steps. Failure to follow this sequence may cause excessive noise and vibration, and reduce engine mount life.
- Wrap the VSA modulator-control unit with the clean shop towel.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Engine Installation

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?