Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE
Engine Lubrication
| Item | Measurement | Qualification | Standard or New | Service Limit |
|---|---|---|---|---|
| Engine oil | Capacity | Engine overhaul | 3.8 L (4.0 US qt) | - |
| Oil change including filter | 3.2L (3.4 US qt) | - | ||
| Oil change without filter | 3.0 L (3.2 US qt) | - | ||
| Oil pump | Inner rotor-to-outer rotor radial clearance | 0.06-0.16 mm (0.003-0.006 in) | 0.20 mm (0.007 in) | |
| Pump housing-to-outer rotor radial clearance | 0.100-0.175 mm (0.004-0.006 in) | 0.20 mm (0.007 in) | ||
| Pump housing-to-rotor axial clearance | 0.02-0.06 mm (0.001-0.002 in) | 0.15 mm (0.005 in) | ||
| Oil pressure with oil temperature at 176°F (80°C) | At idle | 70 kPa (0.7 kgf/cm2 , 10 psi) min. | - | |
| At 3, 000 rpm | 340 kPa (3.5 kgf/cm2 , 50 psi) min. | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.