2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE

USB Adapter Control Unit Replacement

  1. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
  2. Remove the center console armrest (see CENTER CONSOLE ARMREST REPLACEMENT ).
  3. Remove the console box (see COMPONENT LOCATION INDEX ).
  4. Disconnect the connector (A) from the USB adapter control unit (B).
    Fig 1: Connector, USB Adapter Control And Unit Mounting Bolts With Torque Specifications
    G08095046Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the mounting bolts (C) and the USB adapter control unit.
  6. Install the USB adapter control unit in the reverse order of removal.
Chapter Navigation
Return to Chapter: Audio System
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.