2012 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE

VSA Modulator-Control Unit Removal and Installation: Installation

  1. Install the VSA modulator-control unit onto the bracket.
  2. Install the bracket with the VSA modulator-control unit to the body.
  3. Reconnect the six brake lines, then tighten the flare nuts to the specified torque.
  4. Align the connecting surface of the VSA modulator-control unit 47P connector to the VSA modulator-control unit.
  5. Pull up the lever of the VSA modulator-control unit 47P connector, then confirm the connector is fully seated.
  6. Bleed the brake system (see BRAKE SYSTEM BLEEDING ).
  7. Do the VSA modulator-control unit update (see VSA MODULATOR-CONTROL UNIT UPDATE ).
  8. Do the VSA sensor neutral position memorization procedure (see VSA SENSOR NEUTRAL POSITION MEMORIZATION ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.