Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Fit Base, Standard TransFACTORY OEM SERVICE PROCEDURE
Passenger's Power Window Switch Replacement
NOTE:
The graphic shows front passenger's power window switch.
- Remove the door panel:
- Front passenger's (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
- Rear (see REAR DOOR PANEL REMOVAL/INSTALLATION )
- Remove the screws and the grip base (A).
- Open the switch panel (A) from the grip base.
- Remove the screws and replace the passenger's power window switch (B).
- Install the parts in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.