2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

With navigation

WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the lower glove box (see PASSENGER'S DASHBOARD UNDERCOVER REMOVAL/INSTALLATION ).
  2. Remove the mounting bolts (A), and loosen the bolt (B).
    Fig 1: Mounting Bolts With Torque Specifications
    G06768864Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the connectors (C) from the adapter unit (D).
  4. Remove the adapter unit from the bracket.
  5. Install the USB adapter unit in the reverse order of removal.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.