Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
With navigation
SRS components are located in this area. Review the SRS component location (see COMPONENT LOCATION INDEX ). Also review the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) in the SRS section before doing repairs or service.
- Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
- Disconnect the cable reel 20P connector (A).
- Measure the resistance between terminals No. 3 and No. 6 in each switch position according to the table.RESISTANCE REFERENCE CHARTRESISTANCE REFERENCE CHARTRESISTANCE REFERENCE CHART
Position Resistance No button pressed About 10 kΩ MODE About 3.7 kΩ CH (+) About 1.7 kΩ CH(-) About 775 Ω (VOL. UP) About 357 Ω (VOL. DOWN) About 100 Ω - If the resistance is not as specified, replace the audio remote switch.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
