2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Coverage Area

WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

This screen allows the dealer to select the area that applies to their location. The choice is US (continental) or Hawaii. The default is US. Select the choice (the system may reboot), exit the diagnostic mode, and restart the vehicle.

NOTE: This function is designed to operate only when the vehicle is physically located in the coverage area you select.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.