2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

Position Detection Image With GPS Satellite

WARNING: This page is about a different car, the 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Four satellites on each of 6 orbits.

Precision of GPSΒ 

The precision of the GPS varies according to the number of satellites from which signals are received and the view of the sky. The accuracy is indicated by the color of the GPS icon shown on the display.

GPS SATELLITE CONDITION TABLE

GPS ICON COLOR NUMBER OF SATELLITES CONDITION DESCRIPTION
No GPS icon None Faulty reception The GPS can't be utilized due to a faulty GPS receiver, open in the wire, or other fault or interference.
White GPS icon 2 or less Impossible to detect vehicle position GPS function is normal. The satellite signals received by the GPS are too few to detect the vehicle position.
White GPS icon 3 Vehicle position detectable in 2 dimensions The longitude and latitude of the vehicle position can be detected. (Less precise than detection in three dimensions)
Green GPS icon 4 or more Vehicle position detectable in 3 dimensions (elevation displayed) The longitude, latitude and the altitude of the vehicle position can be detected. (More precise than detection in two dimensions)
Fig 1: Identifying Position Detection Image With GPS Satellite
G05960291Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.