Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test: System Links
- Check the vehicle battery condition first.
- Verify that the correct audio-navigation unit is installed for this model. Go into the Diagnostic mode, and use VERSION .
- Check the connectors for poor connections or loose terminals.
- Before troubleshooting, make sure you have anti-theft code for the navigation system.
- After troubleshooting, enter the anti-theft code for the navigation system if necessary.
- Make sure that the correct DVD color and version are installed.
- Inspect the DVD for dirt or damage (see HOW TO IDENTIFY NAVIGATION DVD VERSIONS, AND HOW TO INSPECT A DVD FOR DAMAGE ).
- Check any official Honda service website for more service information about the navigation system.
- Turn the ignition switch to ON (II).
- Check if the navigation system can control the audio and disc functions properly.
Can the navigation system control the audio and disc functions properly?
YES - Intermittent failure, the system is OK at this time.
NO - Go to step 3.
- Go into the Diagnostic mode, and select the Self-Diagnosis Mode diagnostic (see SYSTEM DIAGNOSTIC MODE
).
Is the Radio icon red?
YES - Do the Audio unit power switch will not turn on (no information display and no sound) (with navigation) troubleshooting (see AUDIO UNIT POWER SWITCH WILL NOT TURN ON (NO INFORMATION DISPLAY AND NO SOUND) (WITH NAVIGATION) ).
NO - Substitute a known-good audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ) and recheck. If the symptom gone, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
