Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC P0116: ECT Sensor 1 Range/Performance Problem
- Turn the ignition switch to ON (II).
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Is about 176°F (80°C) or more, or 0.78 V or less indicated?
YES: Go to step 6.
NO: Go to step 3.
- Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
- Start the engine. Hold the engine speed at 3, 000 rpm without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, then let it idle.
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Does ECT SENSOR 1 change 18°F (10°C) or more?
YES: Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the ECM/PCM.
NO: Go to step 11.
- Note the value of ECT SENSOR 1 in the DATA LIST with the HDS.
- Turn the ignition switch to LOCK (0).
- Open the hood, and let the engine cool for 3 hours.
- Turn the ignition switch to ON (II).
- Check ECT SENSOR 1 in the DATA LIST with the HDS.
Did ECT SENSOR 1 change 18°F (10°C) or more from the value in step 6 ?
YES: Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the ECM/PCM.
NO: Go to step 11.
- Turn the ignition switch to LOCK (0).
- Replace ECT sensor 1 (see ECT SENSOR 1 REPLACEMENT ).
- Turn the ignition switch to ON (II).
- Reset the ECM/PCM with the HDS.
- Do ECM/PCM IDLE LEARN PROCEDURE .
- Check for Pending or Confirmed DTCs with the HDS.
Is DTC P0116 indicated?
YES: Check for poor connections or loose terminals at ECT sensor 1 and the ECM/PCM, then go to step 1.
NO: Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC's troubleshooting.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.