Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fuel and Emissions
FUEL AND EMISSIONS SPECIFICATION TABLE
| Item | Measurement | Qualification | Standard or New | Service Limit |
|---|---|---|---|---|
| Fuel pressure regulator | Pressure with fuel pressure gauge connected | - | 320-370 kPa (3.3-3.8 kgf/cm2 , 47-54 psi) | - |
| Fuel tank | Capacity | - | 40 L (10.6 US gal) | - |
| Engine idle | Idle speed without load | M/T in neutral, A/T in N or P | 700 ± 50 rpm | |
| Idle speed with high electrical load (A/C switch on, temperature set to maximum cool, blower fan on high, rear window defogger on, and headlights on high beam) | M/T in neutral, A/T in N or P | 790 ± 50 rpm | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.