2012 Honda Fit Base, Automatic TransFACTORY OEM SERVICE PROCEDURE

VSA Off Switch Test/Replacement

NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned OFF. Check the tire pressure first.
  1. Turn the ignition switch to LOCK (0).
  2. Remove the driver's dashboard lower cover DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION
  3. Push out the VSA OFF switch (A) from the driver's dashboard lower cover.
    Fig 1: Identifying VSA OFF Switch
    G08083033Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. On the switch side, check for continuity between VSA OFF switch 5P connector terminals No. 1 and No. 2. There should be continuity when the button is released, and no continuity when the button is pressed.
    Fig 2: Checking Continuity Between VSA OFF Switch 5P Connector Terminals No. 1 And 2
    G08083034Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.