SRS components are located in this area. Review the SRS component locations COMPONENT LOCATION INDEX and the precautions and procedures PRECAUTIONS AND PROCEDURES

NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.

With the wheels in the straight ahead position and the steering wheel centered, remove the steering wheel STEERING WHEEL REMOVAL
Remove the steering column covers COLUMN COVER REMOVAL/INSTALLATION and the cable reel CABLE REEL REPLACEMENT
Remove the combination switch assembly COMBINATION LIGHT SWITCH TEST/REPLACEMENT
Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).

Fig 1: Removing Combination Light Switch And Wiper/Washer Switch From Combination Switch Body Assembly
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the combination switch body assembly in the reverse order of removal.
NOTE:
- Do not remove the steering angle sensor from the combination switch body.
- When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points straight up CABLE REEL REPLACEMENT
- Tighten the combination switch assembly/cable reel mounting screw in the proper sequence STEERING COLUMN REMOVAL AND INSTALLATION

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Steering Angle Sensor Replacement