Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda CR-Z Base, Standard TransFACTORY OEM SERVICE PROCEDURE
VSA Off Switch Test/Replacement
- Turn the ignition switch to LOCK (0).
- Remove the instrument panel (see INSTRUMENT PANEL REMOVAL/INSTALLATION ).
- Push out the VSA OFF switch (A) from the back of the instrument panel (B).
- On the switch side, check for continuity between the VSA OFF switch 5P connector terminal in each switch position according to the table.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- If the switch does not work as described in the table, replace the switch.
- If the switch tests OK, go to step 5.
- On the switch side, check for continuity between VSA OFF switch 5P connector terminals No. 1 and No. 2. There should be continuity at all times.
- If the continuity is not as specified, remove the cover (A), and replace the bulb (B).
- Install the VSA OFF switch in the reverse order of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.