2012 Honda CR-Z Base, Standard TransFACTORY OEM SERVICE PROCEDURE

VSA Modulator-Control Unit Removal and Installation: Removal

  1. Turn the ignition switch to LOCK (0).
  2. Disconnect the 10 mm brake lines (A) and the 12 mm brake lines (B) from the VSA modulator-control unit (C).
    Fig 1: Identifying Brake Lines And VSA Modulator-Control Unit
    G06953275Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the VSA modulator-control unit 32P connector (A) by pushing the lock (B) and pulling down the lever (C); the connector disconnects itself.
    Fig 2: Disconnecting VSA Modulator-Control Unit 32P Connector
    G06953276Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the VSA modulator-control unit (A) with the bracket (B) from the body.
    Fig 3: Identifying VSA Modulator-Control Unit, Bracket And Wire Harness Clip
    G06953277Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the wire harness clip (C) from the bracket.
  6. Remove the VSA modulator-control unit (A) from the bracket (B).
    Fig 4: Identifying VSA Modulator-Control Unit And Bracket
    G06953278Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.