Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2012 Honda CR-Z Base, Standard TransFACTORY OEM SERVICE PROCEDURE

Power Window Master Switch Replacement

Remove the pocket cap (see DOOR PANEL REMOVAL/INSTALLATION ).
Remove the switch panel from the door panel.
Disconnect the 22P connector (A) from the power window master switch (B).

Fig 1: Identifying Power Window Master Switch With 22P Connector Terminals
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the four screws and the power window master switch (A).

Fig 2: Identifying Power Window Master Switch And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the switch in the reverse order of removal.
After replacement, reset the power window control unit (see RESETTING THE POWER WINDOW CONTROL UNIT ).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.