Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Honda Accord L4-2.4LFACTORY OEM SERVICE PROCEDURE
Engine Compression Inspection (PZEV Models)
Engine Compression Inspection
NOTE: After this inspection, you must reset the PCM. Otherwise the PCM will continue to stop the fuel injectors from operating.
1. Warm up the engine to normal operating temperature (cooling fan comes on).
2. Turn the ignition switch to LOCK (0).
3. Connect the HDS to the DLC.
4. Turn the ignition switch to ON (II).
5. Make sure the HDS communicates, with the vehicle and the PCM. If it does not communicate, troubleshoot the DLC circuit Testing and Inspection.
6. Select ALL INJECTORS STOP in the PGM-FI INSPECTION menu with the HDS.
7. Turn the ignition switch to LOCK (0).
8. Remove the four ignition coils and the four spark plugs Service and Repair.
9. Attach a compression gauge to the spark plug hole.
10. Step on the accelerator pedal to open the throttle fully, then crank the engine with the starter motor, and measure the compression.
11. Measure the compression on the remaining cylinders.
12. If the compression is not within specifications, perform a cylinder leak down test to determine the problem area. Then check the following items, then remeasure the compression:
- Incorrect valve clearance
- Confirmation of camshaft timing
- Damaged of worn cam lobes
- Damaged or worn valves and seats
- Damaged cylinder head gasket
- Damaged or worn piston rings
- Damaged or worn piston and cylinder bore
13. Remove the compression gauge from the spark plug hole.
14. Install the four spark plugs and the four ignition coils.
15. Select PCM reset in the PGM-FI INSPECTION menu to cancel ALL INJECTORS STOP with the HDS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
