2011 Honda Insight LXFACTORY OEM SERVICE PROCEDURE

Torque Specifications - General: Suspension

SUSPENSIONS SPECIFICATIONS CHART

Location Item Remark Torque
Front suspension Wheel nuts   108 N.m (11.0 kgf.m, 80 lbf.ft)
Knuckle damper pinch bolts/nuts Use new bolts/nuts 90 N.m (9.2 kgf.m, 67 lbf.ft)
Lower arm ball joint castle nut Use new nut 64 - 74 N.m (6.5 - 7.5 kgf.m, 47 - 54 lbf.ft)
Lower arm bolts Use new bolts 93 N.m (9.5 kgf.m, 69 lbf.ft)
Stabilizer bar bushing holders flange bolts   22 N.m (2.2 kgf.m, 16 lbf.ft)
Stabilizer link nut flange nut (to damper) Use new nut 29 N.m (3.0 kgf.m, 22 lbf.ft)
Stabilizer link self-locking nut (to stabilizer bar) Use new nut 38 N.m (3.9 kgf.m, 28 lbf.ft)
Damper upper flange nut   44 N.m (4.5 kgf.m, 32 lbf.ft)
Rear suspension Wheel nuts   108 N.m (11.0 kgf.m, 80 lbf.ft)
Axle beam bolts Use new bolts 93 N.m (9.5 kgf.m, 69 lbf.ft)
Dynamic damper nuts Use new nuts 12 N.m (1.2 kgf.m, 9 lbf.ft)
Damper lower flange bolt Use new bolt 54 N.m (5.5 kgf.m, 40 lbf.ft)
Damper upper flange nut   29 N.m (3.0 kgf.m, 22 lbf.ft)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.