Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE
Fuel and Emissions
FUEL AND EMISSIONS SPECIFICATION
| Item | Measurement | Qualification | Standard or New | Service Limit |
|---|---|---|---|---|
| Fuel pressure regulator | Pressure with fuel pressure gauge connected | 260-310 kPa (2.7-3.2 kgf/cm2 , 38-46 psi) | - | |
| Fuel tank | Capacity | 40 L (10.6 US gal) | - | |
| Engine idle | Idle speed without load (IMA battery SOC higher than 30 %) | In N or P | 750 ± 50 rpm | |
| Idle speed with high electric load (A/C on, temperature set to max cool, blower fan motor on high, rear window defogger on, headlights on high beam, and IMA battery SOC higher than 30%) | In N or P | 750 ± 50 rpm | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.