2011 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE

Starter System Circuit Troubleshooting

Special Tools Required 

Alternator, Regulator, Battery, and Starter Tester OTC3131*

*Available through the Honda Tool and Equipment Program 888-424-6857

NOTE:
  • Air temperature must be within 59-100 °F (15-38 °C) during this procedure.
  • After this inspection, you must reset the powertrain control module (PCM). Otherwise the PCM will continue to stop the injectors from functioning. Select PCM reset using the Honda Diagnostic System (HDS) (see HDS CLEAR COMMAND ).
  • The 12 V battery must be in good condition and fully charged.
  1. Connect the alternator, regulator, battery, and starter tester (OTC 3131) to the battery as shown.
    NOTE: The probe is not used for battery testing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.