Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Honda Insight BaseFACTORY OEM SERVICE PROCEDURE
Wipers/Washers DTCS
WIPERS/WASHERS DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC B1028 | Rear Wiper Auto Stop Switch Malfunction |
| DTC B1077 | Windshield Wiper (As) Signal Error |
| DTC B1281 | Front Wiper MIST Position Circuit Malfunction |
| DTC B1282 | Front Wiper INT Position Circuit Malfunction |
| DTC B1283 | Front Wiper LOW Position Circuit Malfunction |
| DTC B1284 | Front Wiper HIGH Position Circuit Malfunction |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.