2011 Honda Fit Base, StandardFACTORY OEM SERVICE PROCEDURE

Starter Performance Test

  1. Disconnect the wires from the M terminal.
  2. Make the connections for this test using the thickest (gauge) wire possible (preferably the same gauge as used on the vehicle).
    NOTE: To avoid damaging the starter, never leave the battery connected for more than 10 seconds.
    3. Fig 1: Identifying Battery
    G05952266Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Connect the battery as shown below. Make sure you disconnect the starter motor wire from the M terminal. If the starter pinion moves out, it is working properly.
  4. Disconnect the battery from the M terminal. If the pinion does not retract, the hold-in coil of the solenoid is working properly.
    Fig 2: Identifying Starter Battery Connection Diagram
    G05952267Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Disconnect the battery from the starter body. If the pinion retracts immediately, it is working properly.
    Fig 3: Identifying Battery Starter Body Connection Diagram
    G05952268Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Firmly clamp the starter in a vise.
  7. Reconnect the wire to the M terminal.
  8. Connect the starter to the battery as shown below, and confirm that the motor runs.
    Fig 4: Connecting Starter To Battery
    G05952269Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. If the electric current meets the specification when the battery voltage is at 11.5 V, the starter is working properly.

    Specification 

    Electric Current: 90 A or less 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.