Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Honda Fit Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Enable Conditions
| Condition | Minimum | Maximum | |||||||
|---|---|---|---|---|---|---|---|---|---|
| Elapsed time after monitor finishing condition except immediate starting the engine | 1.0 second | - | |||||||
| Engine coolant temperature | None, unless the initial engine coolant temperature is 14 °F (-10 °C) or less, in which case the monitor will not run until the engine coolant temperature reaches 68 °F (20 °C) | ||||||||
| Engine speed | 480 rpm(2) 500 rpm(3) |
6,800 rpm | |||||||
| MAP value(1) | 700 rpm | 28 kPa (8.2 inHg, 208 mmHg)(2) 26 kPa (7.5 inHg, 189 mmHg)(3) |
- | ||||||
| 2,500 rpm | 24 kPa (6.9 inHg, 173 mmHg)(2) 21 kPa (6.2 inHg, 155 mmHg)(3) |
- | |||||||
| Fuel feedback | Other than during fuel cut-off operation | ||||||||
| No active DTCs set (prevents monitor from running) | P0107, P0108, P0117, P0118, P0122, P0123, P0222, P0223, P0335, P0339, P1109, P1128, P1129, P2227, P2228, P2229 | ||||||||
| Other | Test-drive on a flat road to avoid misdetection | ||||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.