Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2011 Honda Element EX, 2.4 YH2FACTORY OEM SERVICE PROCEDURE
Engine Electrical
ENGINE ELECTRICAL SPECIFICATIONS CHART
| Location | Item | Remark | Torque |
|---|---|---|---|
| Starting system | Starter bolt (10 mm) | 44 N.m (4.5 kgf.m, 33 lbf.ft) | |
| Starter bolt (12 mm) | 64 N.m (6.5 kgf.m, 47 lbf.ft) | ||
| Starter harness clamp nut | 9 N.m (0.9 kgf.m, 7 lbf.ft) | ||
| Ignition system | Spark plugs | 18 N.m (1.8 kgf.m, 13 lbf.ft) | |
| Charging system | Alternator bolts | 22 N.m (2.2 kgf.m, 16 lbf.ft) | |
| Drive belt auto-tensioner bolts | 22 N.m (2.2 kgf.m, 16 lbf.ft) | ||
| Drive belt auto-tensioner pulley bolt | 56 N.m (5.7 kgf.m, 41 lbf.ft) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.