Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2010 Honda Pilot 2WD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Parts Information
| Part | Manufacturer | OEM Part # | Price | Notes |
| Clip, Wire Harness | HON | 38773PJ7003 | 4.71 | |
| Ring B, Snap | HON | 38812PH1003 | 7.00 | |
| Ring A, Snap | HON | 38812671003 | 5.62 | |
| Plate Set, Washer | HON | 38912PH1N01 | 7.16 | |
| Bracket, Compressor | HON | 38930RN0A00 | 63.70 | |
| Valve Sub-Assembly, Safety | HON | 38801P9KE01 | 45.66 | |
| Stay A, Lead Wire | HON | 38816RYEA01 | 18.47 | |
| Stay B, Lead Wire | HON | 38817RYEA01 | 18.47 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.