2010 Honda Element SC, AutomaticFACTORY OEM SERVICE PROCEDURE

Interface Dial Removal/Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Honda Odyssey, 2016 Honda Odyssey, 2015 Honda Odyssey, 2014 Honda Odyssey, and 2013 Honda Odyssey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the dashboard and related parts.
  • Lay a shop towel under the parts when working on them to protect the face panel from scratches or other damage.
  1. Remove these items:
  2. Remove the audio-navigation unit (see step  2 ).
  3. Remove the screw and the harness cover (A).
    Fig 1: Locating Harness Cover And Interface Dial Connector
    G06971238Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the interface dial connector (B).
  5. Remove the screws, then pull up the interface dial (A) a little with KTC trim tool as shown until the click sound is heard.
    Fig 2: Pulling Up Interface Dial Little With KTC Trim Tool
    G06971239Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Pull the interface dial slowly and steadily by hand until the knob (C) and dial (D) pops off.
  7. Install the interface dial in the reverse order of removal.
    NOTE: If the hard buttons do not work, but the jog dial does, recheck the interface dial connector connection.
Chapter Navigation
Return to Chapter: Section 148 (Navigation System)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.