2010 Honda Element 4WD L4-2.4LFACTORY OEM SERVICE PROCEDURE

Spark Plug: Service and Repair




Ignition Coil and Spark Plug Removal/Installation

1. Remove the ignition coil cover (A).

Factory service manual diagram




2. Disconnect the ignition coil connectors (B), then remove the ignition coils (C).

3. Remove the spark plug (D) and inspect them Testing and Inspection.

4. Apply a small amount of anti-seize compound to the plug threads, and screw the plugs into the cylinder head, finger tight, then tighten the plugs to the specified torque.

Factory service manual diagram




5. Install the ignition coils in the reverse order of removal.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.