ECM/PCM Idle Learn Procedure

ECM/PCM Idle Learn Procedure

The idle learn procedure must be done so the ECM/PCM can learn the engine idle characteristics.

Do the idle learn procedure whenever you do any of these actions:

- Replace the ECM/PCM
- Reset the ECM/PCM
- Update the ECM/PCM
- Replace or clean the throttle body
- Disassemble the engine or the transmission

NOTE: Erasing DTCs with the HDS does not require you to do the idle learn procedure.

Procedure

1. Make sure all electrical items (A/C, audio, lights, etc.) are off.

2. Reset the ECM/PCM with the HDS.

3. Turn the ignition switch to ON (II), and wait 2 seconds.

4. Start the engine. Hold the engine speed at 3,000 rpm without load (A/T in P or N, M/T in neutral) until the radiator fan comes on, or until the engine coolant temperature reaches 194 °F (90 °C).

5. Let the engine idle for about 5 minutes with the throttle fully closed.

NOTE: If the radiator fan comes on, do not include its running time in the 5 minutes.