2010 Honda Element 4WD L4-2.4LFACTORY OEM SERVICE PROCEDURE

Control Assembly: Service and Repair




Heater Control Panel Removal/Installation

1. Remove the center panel Dashboard Center Panel Removal/Installation.

2. Remove the self-tapping screws and the heater control panel (A) from the center panel (B).

Factory service manual diagram




3. Install the control panel in the reverse order of removal. After installation, operate the various functions to see whether they works properly.

4. Run the self-diagnostic function to confirm that there are no problems in the system Initial Inspection and Diagnostic Overview.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.