Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009S2000 BASEREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISPGM-FI SYSTEMDTC TROUBLESHOOTINGDTC P0602: ECM PROGRAMMING ERROR
2009 Honda S2000 Base
DTC P0602: ECM Programming Error
2009 Honda S2000 BaseSECTION DTC P0602: ECM Programming Error
NOTE:
- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
- This DTC is indicated when the ECM update is not completed.
- Do not turn the ignition switch to ACC (I) or to LOCK (0) while updating the ECM. If you do, the ECM can be damaged.
- Do the ECM update procedure (see ECM UPDATE ).
- Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0602 indicated?
YES -Replace the original ECM (see ECM REPLACEMENT ).
NO -The update is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.