Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009S2000 BASEREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISEVAP SYSTEMFTP SENSOR REPLACEMENT
2009 Honda S2000 Base
FTP Sensor Replacement
2009 Honda S2000 BaseSECTION FTP Sensor Replacement
- Remove the EVAP canister (see EVAP CANISTER REPLACEMENT ).
- Disconnect the air tube (A).
- Remove the retaining clip (B)
- Remove the FTP sensor (C).
- Install the sensor in the reverse order of removal with a new O-ring (D).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.