Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2009 Honda S2000 BaseFACTORY OEM SERVICE PROCEDURE
Enable Conditions
ENABLE CONDITIONS
| Condition | Minimum | Maximum |
|---|---|---|
| Elapsed time after starting the engine | 15 seconds | - |
| Engine coolant temperature | 156 °F (69 °C) | - |
| Intake air temperature | 19 °F (-7 °C) | - |
| MAP value | - | 88 kPa (26.0 in.Hg, 660 mmHg) |
| Battery voltage | 10.5 V | - |
| Fuel trim | 0.69 | 1.47 |
| Fuel feedback | Closed loop | |
| No active DTCs | P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0171, P0172, P0222, P0223, P0300, P0301, P0302, P0303, P0304, P0443, P0496, P1109, P1128, P1129, P2101, P2108, P2118, P2122, P2123, P2127, P2128, P2135, P2138, P2176, P2227, P2228, P2229, P2646, P2647, P2648, P2649, U0107 | |
| Other | At idle | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
