Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHONDA2009S2000 BASEREPAIR AND DIAGNOSISENGINE MECHANICALLUBRICATION SYSTEMENGINE LUBRICATION SYSTEMENGINE OIL REPLACEMENT
2009 Honda S2000 Base
Engine Oil Replacement
2009 Honda S2000 BaseSECTION Engine Oil Replacement
- Warm up the engine.
- Remove the drain bolt (A), and drain the engine oil.
- Reinstall the drain bolt with a new washer (B).
- Refill with the recommended oil.
Capacity
At Oil Change:
4.5 L (4.8 US qt)
At Oil Change including Filter:
4.8 L (5.1 US qt)
After Engine Overhaul:
5.6 L (5.9 US qt)
- Run the engine for more than 3 minutes, then check for oil leakage.
- 2006-09 model: Reset the information display.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.