2009 Honda S2000 BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G1 At right rear of engine compartment. See Figure.
G2 On lower left side of engine. See Figure.
G3 At left rear of engine compartment. See Figure.
G4 At lower front side of engine compartment. See Figure.
G101 On rear of engine. See Figure.
G201 At right front of engine compartment. See Figure.
G301 At left front side of engine compartment. See Figure.
G303 At left rear of engine compartment. See Figure.
G351 At right rear of engine compartment. See Figure.
G401 Under left side of dash. See Figure.
G402 Under right side of dash. See Figure.
G501 Behind left kick panel. See Figure.
G502 At right side of audio unit. See Figure.
G601 At left front side of trunk. See Figure.
G602 At rear of trunk, left of trunk latch. See Figure.
G801 Behind lower center of dash. See Figure.
G901 At left side of hardtop. See Figure.
G902 At right side of hardtop. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.